6 Basic Steps to Develop a Motorcycle Map Bag

There are just 6 ways needed to make your own motorcycle bag: get ready the materials, sew the 2 vinyl sheets together, measure and also indicate the button and button hole areas, make the button hole cut, sew the button opening ends and button into place, and finally, slide the map within the motorbike bag.

Maps are obviously very important to carry along on travels since they give you the directions you require. Nonetheless, they can simply get unclean and also damaged, especially when you're on the open road on your own motorbike. To maintain the reliability of the map and ensure that you not only have the correct directions but are also able to use your map in the future, you have to keep your maps in vinyl envelopes or map bags. This information will direct you through the steps to create a map bag for your own map.

Get ready the materials

The very first thing that you must do to create a map bag is find the required materials. These include thread, a needle, 2 pieces of fifteen-inch-square vinyl, a set of scissors, a one half diameter button, a map, a pen, and a measuring tape.

Stitch 2 vinyl sheets jointly

Get your needle and also thread and stitch the 2 bits of vinyl together. Stitch only 3 sides, which will make a square-shape envelope, fifteen inches in size.

Measure and mark button and button hole areas

With the use of the measuring tape, measure 7 1/2 inches from the open edge of the envelope towards the middle and tag this spot with the pen. Next, estimate and also mark again 1 1/2 inches along the 7 1/2 inch line from the open side towards the marked area you just made. This will be the place where the button would close.

Make the button opening cut

Around the mark you just created that was one and one half inches from the side, cut a button opening that's a half-inch in size. Make use of the scissors to get this done.

Sew button hole edges and button into place

Using your needle as well as thread, stitch the edges of the button opening to prevent them from unraveling. After that, sew the button into place through putting one of your fingers inside the envelope and beneath the button opening.

Slip map within motorcycle bag

Flip the map and also insert it in the vinyl envelope. Next position the button over the button hole to keep the map secure inside the envelope. Because your new motorbike map bag made from vinyl envelope is now finished, you can now place this within your motorcycle's glove or helmet pocket.

When performing a sewing activity, particularly involving the application of razor-sharp needles, be watchful and vigilant. If you do not focus on what you are doing, you can simply prick yourself. You could also use thimble to give your fingers additional protection.

Article Source: http://www.easyarticlesubmit.com

Rate this Article 5 out of 54 out of 53 out of 52 out of 51 out of 5  Not yet Rated	Bookmark This Article Facebook, Twitter, Del.ici.ous, etc
Click the XML Icon Above to Receive Motorcycles Articles Via RSS! Article Summary: